Image

PRECAST & PRESTRESSED CONCRETE

Product overview

The P-24F and P-20F sections are most commonly used for Fender Pile applications. Recommended strand locations are provided.

Categories
Explore specifications ↓

Key specifications

Fender Pile - section summary
Section / featureSource detailCoordination notes
P20F20 in fender pileP20S general notes and properties apply
P24F24 in fender pileP24S general notes and properties apply
Face-panel hardwareStainless steel insertsCoordinate locations with strands

Design & detailing notes

  • The P20F and P24F drawings provide recommended strand and stainless steel insert layouts.
  • Insert locations must avoid strands. Inserts are normally recessed to allow hardware and template setting.
  • The outboard face is specified as a form finish in the source drawings.
  • The source notes describe ¾ in diameter inserts as standard hardware for attaching UHMW face panels. Confirm the insert and panel requirements for the project.
  • Use the corresponding P20S or P24S sheets for general pile notes and section properties.
Source drawings
  • 2-23-10 SQUARE PILE.pdf: P20F, P24F, P20S, P24S

This summary supports preliminary product selection. Refer to the complete source drawings and coordinate final dimensions, loads and reinforcing with GPRM and the project engineer. The supplied sheets do not show an issued or revised date.